KC9ON Foxhunt Offset Attenuator V5d Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for the KC9ON Foxhunt Offset Attenuator (V5d) with SMA connections and an optional handle clamp.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 21
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a basic case for the KC9OF offset attenuator. The box is designed such that you can add SMA (female) bulkhead-style connectors to the side. I used RG-174 to connect them to the board. The lid to the case is locked in place with a single 4-40 x 3/8" screw that threads into a tab on the lid, no other hardware is required. I also designed a clamping mechanism so that I could attach it to my tape-measure yagi antenna. It specifically fits around this handle, and FWIW, I used these mounts to build the yagi. The clamp uses two zip ties that are about 1/8" wide. Make sure to use supports if you are going to print the clamp. I attached the clamp to the box with two part epoxy.