13 modeli
Remixed to fit my ESP32 Post-Printing The cover isn't press fit, so maybe you need to seccure it somehow else. How I Designed This I took the Step-file and imported it into Fusion360. Category: DIY
This 3D model is an ESP-32 mount that uses clips to lock the circuit board in place. You can use it as a stand when working on your projects or you can embed it in any cases you'd like to design. You need to print the following parts: 1…
A simple two-piece case for the AZDelivery ESP32 board. Additional material needed: 4 M3x10 cylinder head screws 4 M3x4 cylinder head screws 8 M3 nuts The board is screwed onto the bottom part using the M3x4 screws and 4 nuts. After that,…
I've converted an old iPad Air to run without battery and I needed a small box that contains the XL4015 converter used to lower the input voltage to the 3.73v that were provided by the battery. And so here it is. :) It requires 2 M3 brass…
This enclosure is designed specifically for the AZDelivery ESP32 Dev Kit C V4, used in combination with a DHT22 temperature and humidity sensor connected via cable. Not suitable for other ESP32 layouts without modification.
These were delivered in a cardboard box with antistatic bag - I needed a better storage container, the lid is clipped on tight but comes off easy. Hope someone else can get some use out of it.
A OpenSCAD case for AZDelivery FT232RL adapter, to fully enclose the adapter, with "pad" to ZIP-tie the jumper cables. Originally the ZIP-tie pad was flat, but it was way too easy to break it off. Then I changed to this triangular-ish…
This is a 2-part case for AZDelivery dual-channel 5V Solid-State relay module. Made in OpenSCAD, so it is fully parametric. LEDs are visible (there are holes to let the light though), as well as the screw terminals are accessible.…
A OpenSCAD case for AZDelivery FT232RL adapter, to fully enclose the adapter, with "pad" to ZIP-tie the jumper cables. Originally the ZIP-tie pad was flat, but it was way too easy to break it off. Then I changed to this triangular-ish…
This is a 2-part case for AZDelivery dual-channel 5V Solid-State relay module. Made in OpenSCAD, so it is fully parametric. LEDs are visible (there are holes to let the light though), as well as the screw terminals are accessible.…
This is similar to other cases but not quite the same, its been designed around the AZDelivery board that I purchased through Amazon ( AZDelivery NodeMCU WiFi Lolin V3 ESP8266 ESP-12F Internet Development Board Module (32mbit) Flash…
Basic Explanation This is a simple holder that is made to store prototype boards that can drop onto a Gridfinity plate. It takes up two slots on the baseplate and is not stackable. There are no holes at the bottom for magnets . This…
This 3D model is an AZDelivery OLED mount that uses clips to lock the circuit board in place. You can use it as a stand when working on your projects or you can embed it in any enclosure that you design. You need to print the following…
