Wyniki wyszukiwania: b95

Sony MDR-XB950BT Hinge Replacement Swivel

Print on the side with 100% infill and support (easy to remove).

MDR XB950BT Hinge Now Solder Less

V2: I have remade the hinge and it is now solder less. Some people had requested to make it different since not everyone was conformable soldering and the previous non solder I agree was bulky and ugly. You no longer need the metal pin,…

Hinge for Sony MDR XB950B1

No soldering required. Suggested to print with walls enough for 100% infill and in petg or asa for flex/give to hold up.

Sony MDR-XB950BT swivel replacement

The Sony MDR-XB950BT Headphones are really nice and comfy but they appear to somewhat frail. I purchased 2 and both broke in the exact same way. The swivels that hold the earpieces in place at both ends of the headband are prone to break…

Sony MDR XB9501 replacement

New Holland B95 backhoe latch

New Holland B95 backhoe window hinge latch. I add material to the rear pin hole to help strengthen it, the factory one tends to break in this spot. I recommend 7 perimeter on this print for strength and print it with PET. PLA is to weak…

right cover sony MDR-XB950B1 MDR XB950B1

If you find my work useful you can: paypal.me: https://www.paypal.com/paypalme/printyourfix Visit my website for contact form: https://printyourfix.com/ Follow me on Instagram: https://www.instagram.com/printyourfix/ Visit YT channel:…

MikroTik RB951G-2HnD 10" Rack panel

10" Rack panel for MikroTik RB951G-2HnD

10 inch rack mount for Mikrotik RB951 and Tapo Hub H200

Printed with ASA, 3 wall and 15% infill. Both have a tight fit so just need to make the flush with front. The Tapo H200 was used with rubber feets and Rb951 without rubber feets After printing, I drilled 2 small holes and then used wire…

Swivel Retainer for Sony MDR XB950N1

This is swivel retainer replacement for Sony MDR XB950N1 headphones. Original metal part is about 0.75mm thickness but you can print different sizes and pick which one fits the best. Both PETG and PLA works well. The reason I designed it…

MikroTik RB951G-2HnD 10" Rack panel

10" Rack panel for MikroTik RB951G-2HnD

Swivel Retainer for Sony MDR XB950N1

This is swivel retainer replacement for Sony MDR XB950N1 headphones. Original metal part is about 0.75mm thickness but you can print different sizes and pick which one fits the best. Both PETG and PLA works well. The reason I designed it…

MDR-XB950B1 Non-Perminant Hinge

This version sacrifices a little bit of strength in an already under-built part to have a cutout so the wire can pass through when assembling rather than having to de-solder the wires to get it out. Removing the original piece requires…

Sony MDR-XB950BT and MDR-XB950B1 Brace strength remix

I used the original brace for quite some time, but if printed in PLA it always loosened after some time. This remix addresses that and lasts a lot longer than the original and in my opinion even looks better. Category: Audio