Liczymy pasujące modele…
for mounting GPS receiver on quadcopter drone on the nose over the FPV camera FITS: Lumenier QAV-S 2 Sub250 Joshua Bardwell SE 3in frame link HGLRC M100_Mini GPS link MATERIALS: TPU 95A (optional) M3x6 or M3x8 screws (4 each) PRINTING…
Second Version of my Runcam Thumb Pro Baseplate for the Lumenier QAV-S Bardwell Edition FPV Frame I have to reprint mine so I make a few improvements. The Cam is more in the front. The Screw-Holes are tighter A Version with a mount for a…
Landing feet designed to specifically fit the JB QAV-S 2, 5" drone Printed with a Prusa MK3, I used 80% infill and M3x8mm screws. Other prints just didn't quite have enough wiggle room in the bolt pattern. These fit flawlessly! The TPU…
Rear dual antenna mount for receiver (RP1) and VTX antennas with a swappable VTX antenna SMA connector. Printed in TPU with a brim for adhesion. It has survived quite a few falls, so I thought I would share.
Lumenier QUV-S 2 Joshua Bardwell edition Gopro Hero 8 mount 22.5 degree ND filter compatible Printed in TPU
This is a CADDX Peanut Support for the QAV-S Joshua Bardwell Edition Frame. I didn't do much design on this one, please be sure to check the sources and thank them :) Category: R/C Vehicles
Rear dual antenna mount for receiver (RP1) and VTX antennas with a swappable VTX antenna SMA connector. Printed in TPU with a brim for adhesion. It has survived quite a few falls, so I thought I would share.
Landing feet designed to specifically fit the JB QAV-S 2, 5" drone Printed with a Prusa MK3, I used 80% infill and M3x8mm screws. Other prints just didn't quite have enough wiggle room in the bolt pattern. These fit flawlessly! The TPU…
The front of the frame standoffs are narrower than the next spot back of standoffs which makes printing a little more difficult. Also the typical way of mounting the GoPro using the next standoffs is too far in my opinion. This design…
Simple antenna mount for Lumenier QAV-S (Joshua Bardwell Edition) frame.
