Liczymy pasujące modele…
Cricut's $30 brayer is a scam, so I cloned it. This design requires 2x M4x12 bolts, 2x nuts, and 2 608 Ball Bearings This can be used as is or you can buy/glue $.99 foam paper from a craft store to the roller for a truer clone of Cricut's…
STLs for 3d printing a hard brayer. You could use it without rubber to make a roller for applying pressure. My settings: Layer Height: 0.2 Wall line count: 2 Print Order: Inside to Outside Alternate extra wall: Yes Bottom Layers: 4 Top…
My wife needed a brayer for the vinyl crafts, so I put together one using whatever hardware I had at hand. The goal was to make it as strong and resiliant as possible, so I reinforced all the critical areas with metal: The pins that…
A device to hold three Speedball brayers standing upright. I use two of these, one sits on my workbench where I make prints and the other sits next to the sink as a “drying rack” after I wash the brayers.
I have several Speedball brayers for rolling ink and I wanted to hang them on pegboard but I couldn't find a holder so I decided to to make my own.
Used to hold a 4" brayer from speed ball on the Honey Comb Wall
This is a replacement handle for cheap mini rubber rollers. The roller wheel on these is about 34.5mm long and a diameter of 22mm. These come with a M4 screw that is about 46mm long that you will need for the replacement handle. REQUIRED:…
This is a basic roller. It prints in 2 parts and uses 2 x 608 bearings. The last photo shows the extra mod to print for a round handle. Just super glue it on top.
