Liczymy pasujące modele…
Introduction This is a simple scale model of the Civetta, a famous Italian mountain. I did this by extrapolating the elevation data of the area from Google Earth, subsequently processing them with a special plugin The model aims to offer…
Wydruk około 38,52 €–47,08 € nettoWstępna wycena jednego wariantu
Un panneau avec lettrage en relief, à mettre au pied d'un plant de cive/ciboule, avec le nom scientifique en dessous. Print instructions Print the layers from 0 to 1.5mm in one color, and the layers after that in another color to have the…
Wydruk około 0,58 €–0,71 € nettoWstępna wycena jednego wariantu
Gopro 8,9,10,11 and 12 case to protect the camera's body. This case must be printed in tpu filament to allow a better fitting.
Not my model and have not printed yet will post a make of the model when I do print it.
I've noticed that when I place a straight track directly after the GraviTrax Power Lever, the ball sometimes doesn't land on the track. I've increased the width of the rail and raised the ball catch position, resulting in a sloping…
Mit nur 2g ist dieser Halter für einen Multiplex RX7 light Empfänger extrem leicht und ein muss für jedes Modellflugzeug. Druckparameter Material ASA Drucker Voron 2.4 Support Tree support Layer hight 0,2mm Infill 15%
modification of a thingiverse model. https://www.thingiverse.com/thing:1715725/comments
This is a quick print that adds an analog receiver mount to the Caddx Walksnail Goggles X. All you need is an analog receiver such as the TBS Fusion (In the photos) or any analog modual that will fit into a FatShark/HD0 Module bay. A…
V2: Die Kante am Fuß ist abgerundet und das Kaffepulver kann nicht mehr hängen bleiben. Ich habe einen Auffangbehälter mit einer größeren Standfläche konstruiert. Mit dem Originalen ist mir meine Mühle öfters umgefallen. Für einen festen…
I noticed somebody in the Kickstarter asked for a pen-spring BB gun. After playing around with such a thing, it wasn't very easy to print on a lower speced or lesser dialed-in printer (Which was the whole idea!), so I opted for something…
Lipos must not be left in the car. So I was looking for a solution to quickly swap the 2S receiver lipo on my old HPI Baja 5B. Lid fits directly onto the original receiver box. Eight 5x20x2mm neodymium magnets are required. Magnets must…
Place the logo or sticker of the car you dislike in the center and show it off proud.
This case is made to fit all ESP receivers made on the design from NODE-MCU both the wider and smaller one fits. The case holds all wires and the radio receiver for IKEA sparsnäs plus the NODE-MCU controller board. To build your own…
ENGLISH: Humorous Sign/poster for businesses where the access door is double and the customer always tries to open the wrong one. Available in Spanish and English, with the arrows in both directions (be sure to print the corresponding…
Just a mount for Xbox360 wireless reciver wich you can mount under your desk using double-sided tape.
modification of a thingiverse model. https://www.thingiverse.com/thing:1715725/comments
PRINT SETTINGS 8-15% infill based on preference. 5 top layers, 7 if 8% infill. 2-3 outer walls. No supports. Raft or brim if you have adhesion issues. Scale Settings: PLANTER & TRAY 3" OPENING: SCALE 68.04% 3.5" OPENING: SCALE 79.38% 4"…
