Liczymy pasujące modele…
This latch is very strong to close a closet or drawer with big power. I designed the latch for my closet. Our cats always tried to open the door and do some chaos with our clothings. With this latch the door is always closed.
A set of easy to print latch and lock to baby-proof drawers, closets, cabinets, etc. by making them harder to open for babies (but not adults). The pieces are easy to install using wood-screws of 3 to 4mm diameter (and approximately 15mm…
just a way to store a large amount of spools inside a closet or on a shelf with easy sorting and manageing. The Parts are 20cm and 10cm long. Just stick them together and print as many as you need. The left and Right arre there as well.…
We kept being annoyed by clothes hangers sliding off the end of the rods in our closet, so I whipped up these quick press-fit end caps to keep them on. We have an Everbilt wire closet setup from Home Depot which uses ¾" hollow rods, this…
The largest tray/box on bottom is 12in x 8in x 5in (L x W x H) although you can always mess with it in oyur slicer or cad system. (I used tinkercad) The next biggest one is 11in x 7in x 5in (L x W x H) again, you can mess with it in your…
Parts to hang hats on Dakota Closets shelving units. Two, 5mm x 10mm Euro screws attach the brackets to the units. Example of screws .
Want to mount Multiboard to your Ikea Aurdal 15" closet but don't want to create holes? Want better support than just command strips? This offset snap mount lets you use the existing screw holes! You only need this for one side of the…
Slap on a label, clip this to your wire racks, and have the most organized closet around! Printed with grey PETG (because it was already loaded - PLA will be fine) @ 25% infill. Labels printed with a small thermal label printer (the…
The Dakota Closets system from Menard's is pretty nice, but the location of the wardrobe rods are too far forward. This template helps with drilling new holes 3" back from where they are now. Note that some of the uprights I have use…
Large, 28mm Long, 4.75mm Round Shelf Pin for California Closets. Made since I was trying to modify someone else's in blender that was a basic 5mm pin size and it just kept not coming out right. So I made my own in Fusion 360. It's long…
Wife didn't like the tab handles that came with the California Closets mirror doors. So made a design modeled after the drawer hardware in the closet so they matched. Handles are attached to mirror door frame with 3M VHB and printed in…
CA Closets rear channel mount for Philips Hue Gradient Ambience Lightstrip
My closet has some odd rubberized robe hooks. One was missing its center plug, so it would constantly come apart. Nothing a 3D printer and some PETG couldn't fix, though! I think this is a California Closets system from the 2000's, but no…
This is just a simple update to the other peg hook. This one is longer and will allow for more things to hang off of it including empty backpacks and the full width of a snap back baseball cap like a Richardson trucker hat.
Its really easy to print but u have to bare in mind that you only need supports for the bottom and infill above 15% . Keep the speeds and temps low for better results .I used fuzzy skin for this but you can save time with it off . PLA…
Switchbot Lock door knob mount plate for closets
Slap on a label, clip this to your wire racks, and have the most organized closet around! Printed with grey PETG (because it was already loaded - PLA will be fine) @ 25% infill. Labels printed with a small thermal label printer (the…
