Liczymy pasujące modele…
This Nalgene adaptor was designed for a Mitsubishi Colt drinks holder but should work in cars with a similarly dimensioned holder (75.5mm upper diameter, 72mm lower diameter and 55mm depth). The holder also has a hollow base to allow…
Vacuum accessory holders to be mounted to the vacuum using 3M Command Strips or double sided tape. Though these should work with any 40mm diameter vacuum accessories, they were designed specifically for the Shark Vertex Pro Powered Lift…
Print with PETG or other high temperature material. You need the retainers 2 times and slot it into the main body before installation. To mimic the existing trim, print with small "fuzzy skin" enabled in the slice - if your slicer…
Printed with PLA and three perimeters. Should snap right on to the main vacuum and then parts snap on after. If the snap is too tight, you can warm it with a hair dryer just a little and it will loosen up.
2020 Frame mount, CZ300 heated bed mount, and links to protect the bed wires
