16 modeli
Clips to make Ikea Dioder LED bars clip nicely into an Ikea Detolf case. Print instructions Print six of the light bar clips to attach the Dioder Bars to the Detolf rails. Print a bunch of the wire clips to keep the Dioder wires tidy.…
Ich habe Halter konstruiert um die Dioder Strip's von IKEA an meinen Anycubic i3 Mega S zu montieren. Diese werden nur gesteckt und können bei Bedarf schnell entfernt werden. Es werden 6x Halter benötigt.…
Clip for the DIODER LED strip from IKEA. Angled by 45° for a good lighting in my Lack enclosure. Screwed to the table legs using wood screws with 4mm diameter. The dioder strips fit snug so they will not move. I am not sure whether there…
A simple bracket to mount your IKEA dioder (RGB) to any surface with two #6 screws. Can be printed flat with no issues.
Another take to mount the IKEA Dioder bars to an Ender 3. The holders slide in from the side into the 2020 V-Slot Extrusion. You'll need to print two of course. It's a quite tight fit by design so it doesn't wiggle around, you can…
Screw mount for Ikea DIODER led strips
This is both a mount and a diffuser for an Ikea Dioder led strip (25 cm length). I needed the diffuser, but since I designed the diffuser it was easy to put the mounting points on the other side and make a mount version, so without…
Ikea make small round LED lights for fitting in cupboards in 4 packs. When you are chilling out in the evenings with the lights dimmed it is annoying to have the direct light shining at you from the LEDs. This shade is push-fit and solves…
Model holds 2 dioder lights about 105mm from the top aluminum extrusion on an Ender 3. This is designed to fit the RGB dioder lights. Printed in PLA with 10% infill and 0.3mm layers.
Clips to attach IKEA Dioder rods to 17mm shelves. On rough surfaces, the clips only need to be plugged, they hold through the small prongs. It can also be fixed from above or below with 3mm wood screws. 5 versions with 0 °, 45 °, 90 °,…
Remixed the lamp to mount Dioder L1327 multi-colour led lamps. New mount for lamp, to mount, remove the metal mounting plate, then snap the lamp in the mount. (The pivot point should point toward where the metal plate was, photo will…
I was inspired by DulleNuss's Dioder clip to make one to hold 2 of the Dioder lights. Use 2 pair of these brackets to hold the full set. I first designed a bracket to hold 2 of the RGB lights, since I had a set laying around for literally…
A simple mount to place your Ikea Dioder light strip controller in, and mount to the Skadis board.
I replaced my IKEA Lack shelf for a new one with more space and more stability. So i had to find a new place for my Dioders. I wanted to have them nearer to the build plate so i threw this design together. It's a small print on the clips…
Simple print, print in the stl orientation, the overhangs should not be a problem. Designed in OnShape, link is attached to the files.
This is a wall mount for a RGB Dioder strip from IKEA. I think these strips are discontinued, I got mine years and years ago, but this works perfect if you have some. Category: Parts
