IKEA Dioder 2 light clip - CR 10 / Ender 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was inspired by DulleNuss's Dioder clip to make one to hold 2 of the Dioder lights. Use 2 pair of these brackets to…
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 1
- Wyświetlenia
- 238
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I was inspired by DulleNuss's Dioder clip to make one to hold 2 of the Dioder lights. Use 2 pair of these brackets to hold the full set.
I first designed a bracket to hold 2 of the RGB lights, since I had a set laying around for literally years for this exact purpose. After getting everything mounted and set, I found the light to be too blue/red, and so went out and got a pure white Dioder set.
So there are two versions here:
the "RGB" is for the RGB set and the "WHT" is for the pure white set.
Everything is snap fit, the RGB version is probably a little more effort to snap in than the WHT version.
For fitting to the printer, I found it easiest to rotate the clip up from the bottom of the cross brace.
NOTE: You will probably lose a little height since the lights are angled down slightly, like the originals.
Print Settings
Printer Brand:
Creality
Printer:
CR10S PRO
No
Supports:
No
200
Infill:
20
Filament:
Inland PLA Blue
Category: 3D Printer Accessories