IKEA Dioder 2 light clip - CR 10 / Ender 3

I was inspired by DulleNuss's Dioder clip to make one to hold 2 of the Dioder lights. Use 2 pair of these brackets to hold the full set.

I first designed a bracket to hold 2 of the RGB lights, since I had a set laying around for literally years for this exact purpose. After getting everything mounted and set, I found the light to be too blue/red, and so went out and got a pure white Dioder set.

So there are two versions here:

the "RGB" is for the RGB set and the "WHT" is for the pure white set.

Everything is snap fit, the RGB version is probably a little more effort to snap in than the WHT version.

For fitting to the printer, I found it easiest to rotate the clip up from the bottom of the cross brace.

NOTE: You will probably lose a little height since the lights are angled down slightly, like the originals.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament:
Inland PLA Blue

Category: 3D Printer Accessories