Liczymy pasujące modele…
Here is my doserless mod for my Mazzer Super Jolly grinder. This grinder is an older version with a different sized motor cover cutout. Therefore I have made my own cover for it. The coffee shoot is a 32.5mm steel tube that I cut to size.…
Wydruk około 1,02 €–1,25 € nettoWstępna wycena jednego wariantu
Remix of a Mazzer Mini Doserless Funnel from Thingiverse, the lower part has been enlarged by 16.4mm to fill the gap for the Super Jolly.
A doserless conversion for the Rancilio Rocky. This remix uses an open chute so you can clear out the retained grinds. The Rocky retains ~1g of coffee and this lets you clean it out easily. You'll also need to print the retention clip…
A doserless conversion for the Rancilio Rocky. This remix uses an open chute so you can clear out the retained grinds. The Rocky retains ~1g of coffee and this lets you clean it out easily. You'll also need to print the retention clip…
I introduce a bellows system for the Rancilio Rocky Doserless grinder. I've been drinking a lot of filter coffee recently. Instead of adjusting my other grinder between espresso and filter settings, I pulled the Rocky Doserless out of the…
I printed mine in PLA, 0.2 mm height, 20% infill, 3 walls (4 or 5 would be better). I also made improvements to make it stepless, minor improvements or adaptions to the funnel and anti-popcorn lid. Consider also printing: Stepless…
This cup fit on a Super Jolly doserless and can be used to weight grains and just be put on top of the grinder in a single movement.
Print the shute with support (I prefer the snug since it's easier to remove). I used a TPU from Overture, 95A, for the seal: https://geni.us/4Qa3O (obs: affiliate link, but you don't pay more if you buy from this link). Consider also…
Rancilio Rocky doserless Conversion with adapter and swappable spouts/chute. It uses the same retaining clip as the original conversion model but i redesigned the rest. Adapter was printed face down with support for notches and spout…
If you want to go this route, prepare angle grinder :) So far there are 2 main components: - Funnel which I use with printed TPU bellows. This is press fit and should be fine for the angle of legs - Legs and spacer to support the grinder…
Mod Kit Doserless HC600 HeyCafe
This model consists of a base and two pins. For assembly, insert the two pins into the base and then align the pins with the holes in your Rancilio Rocky grinder and push the assembly into them. If you replace the momentary switch on your…
This remix modifies the original unit to fit a Compak K6 (WBC edition) with a doserless mod. I made the screw mounting holes vertically stretched as, at least on my model, the two screws are not at the same elevation (those whacky…
