Liczymy pasujące modele…
Just print the top part with 30% infill. It snap fit on the pole. The bottom part is not tested yet with the tent. The goal was to fasten the plastic part to the tent, then when stending up the tent the pole just need to push into that…
The Durston X-Dome tent can be reinforced by using a trekking pole at each end of the cross bar. If you don't use trekking poles, Durston also sells the Z-Flick poles that are very light at only 88 g per piece. However, the X-Dome is not…
The durston roads are not enough long for the astagear yun chuan 2 tent. So I made an extender for both sides. Printed with 100% infill, from ABS but PETG is good to. After the print I heated up the modell with a hairdryer, and pushed to…
I created a model for some Rubber Tips for my new Durston Iceline Trekking Poles. I have the second Edition of the poles from late 2024. I think that the tips should fit the first edition as well, but I don't know for sure. I recommend…
I created this small plate as support for my stakes. In our wet grassy ground the stakes sank into the ground. Therefore this plate increase surface are. The plate has a little bit larger interface than the 14mm Durston stake. The design…
Basket for Durston Iceline Trekking Poles The stock ones have been out for stock for some time so I made these, heavier I'm sure but better than nothing. Prints with supports in the center. Printed with 100% infill, in petg-cf though I'm…
