Liczymy pasujące modele…
Ce porte canette (double) pour BMW E87-81-82 est parfait pour combler le petit vide poche inutile de nos voitures, Étant destiné a être mis dans une voiture, je conseille fortement de l'imprimer en ABS (ou tout autre matériaux résistant…
Please print with 6 wall loops, don't be shy with plastic, this is a case, it needs to be strong. Print it like on the last picture, this is the best way. Supports are very easy to remove, don't be afraid using them. I didn't found the…
Just a simple silhouette of my friend's BMW, he needed a wall decoration in garage. Big model is about 600mm x 180 mm. Whole model have a small size and can be a keychain i think (scale it >75mm by X axis) Mounted on the wall only for…
Paciente8159's CNC probe This is my take on a CNC probe with some special features which are: No electronics. This probe has no special built in electronics, contact PCB nor electronic circuit (you can add one it if you want to)…
Replacement BMW 1 series aero kit rear bumper grill. Mine went missing so made this version. This is the first attempt at making a 3d printable file and a absolute beginner. Due to my printer size I had to print this at an angle to fit…
There are two version available. I use the snug version as I don't take my drive often, but if you do, try the loose version first.
Irobri's P3Steel v2.01 redesigned by Paciente8159 (v2.2) This a redesign of irobri's near perfect P3Steel 3mm steel laser cut v2.01 3D printer I actually have one ( and I love it ) an these changes reflect some of the things I would like…
Scatola ricevente per Hb e817/v2 piu piccola dell'originale ideale per Sanwa rx482,io lo stampato in Petg carbon ma si puo fare tranquillamente anche in Pla..... Category: R/C Vehicles
I removed the bottom tab as it was too thick for some cases I used the screws that came with the card, I don't know what size they are. The holes are 2,5mm Also check out my Fan Bracket…
porta batterie lipo e spessori da mettere sotto tra il telaio e il porta batterie stesso sfruttando i fori del telaio gia presenti...... e consigliato usate petg o pla carbon.......... MI FAREBBE MOLTO PIACERE VEDERE LE VOSTRE…
Designed for a Noctua NF-A4x10 FLX, but should fit with any 40x40x10mm fan Also check out my PCIe Bracket https://www.printables.com/model/1403187-qlogic-qle8142-ibmx-pcie-bracket
A simple stand to raise my Yamaha E810 set on my desk. This way there is better ventilation, my Raspberry Pi can fit under it and cabling can run under the set
I needed a set of feet to hold a single 2020 and 2040 extrusion on a table more nicely than just sitting there. See photos for how it sits with this foot. As with the original, it's designed for M4 SHCS with t nut of your choosing.
A fan shroud designed for a low profile e810-XXVDA4. Uses a 5015 blower fan. Updated: thinner, should be able to fit next to another card now. Print both parts. The body may need supports for the channel on the lower half ( it will be…
Shroud tested on Intel lE810-XXVDA2 . Likely compatible with multiple Intel NICs such as x520-T2 . Designed with Noctua NF-A4x10 FLX . (untested) Printed on Creality CR6SE .
