Liczymy pasujące modele…
In winter time when charging the akkupack of my bullitt EP8 sometimes the open contact of the mount were flooded during rain - in the morning when I placed the powerpack the electronics promted an error during short-circuit fail. So I…
I broke my original chain guide on my shimano ep8 mountain bike, used the pieces to get the dimensions and measure up a temporary replacement which uses the stock metal insert to get me through until my local shop had a replacement in…
Wandbefestigung für ein Ladegerät
Um meine Ladegerät an der wand zu befestigen
AI generated cars! 1994 Toyota Starlet ep80 White Picture is lower poly (V1) Pink picture is higher poly (V2) two different versions of the same car to choose from. I was surprised by the results when I tried using AI This was done by…
Print upside down, lying flat on the top.
Here is a video of the entire process of making this part. Print with ABS or ASA standard settings with supports and brim. orientation and other settings in video.
Print as in with supports on. Preferably in PET-G or ABS, PLA might be too stiff. Mount with double sided tape or two wood screws (3mm). In the photo it's the V1, V2 includes better clearance and clips for the included nozzles, 2 mounted…
This lid is intended to fit the NokBox 8x8 TTRPG Dice Box found here: LINK Graphic recreated in Solidworks using the following as a reference: LINK I recommend printing it graphic side down on a textured build-plate using the “Only 1 wall…
For mounting the power supply unit for Shimano EP8 E-Bike motor in a shed or garage. The power supply can be easily removed. No supports required.
I use those for reverse engineering the can bus protocol between the battery and the rest of the system (motor, screen, charger, ...) You can check the progress here:…
Here is a video of the entire process of making this part. Print with ABS or ASA standard settings with supports and brim. orientation and other settings in video.
I use those for reverse engineering the can bus protocol between the battery and the rest of the system (motor, screen, charger, ...) You can check the progress here:…
HEY i was tired of small rocks going between my motor and frame with the possibility of damaging the motor and also having them rattle drove me insane so made this that solved it and also no heatsoak problems printed in TPU also the rear…
The handlebar switch for the Shimano EP8 (STEPS SW-EM800-L) seems to break off quite easily. Since I couldn't find a replacement part, this is what I came up with. Depending on how your switch broke off, you might have to take the switch…
HEY i was tired of small rocks going between my motor and frame with the possibility of damaging the motor and also having them rattle drove me insane so made this that solved it and also no heatsoak problems printed in TPU also the rear…
