Liczymy pasujące modele…
I've only uploaded the files I changed, the others can be obtained from Hex2000's post. Note: you may need to change your infill settings to get these to balance just right. It was a bit of trial and error for me.
I have a Begode EX20S suspension unicycle, and found that I wasn't really able to use the upper stock power pads very well, as the 'gap' between the front and rear pads is quite large so I found I wasn't even moving my leg back far enough…
I designed these with a spider web motif, and suggest printing in PETG, or you could try TPU if you're comfortable printing with supports in TPU (I haven't figured that out yet so mine were a mess). They're not large, but provide some…
The bottom corners of the aluminum battery cases on the EX20S are relatively exposed, especially on tight trails and on compression of the suspension and/or tire. I designed these corner protectors to protect the cases from scratches and…
This rear grip fits directly over the sharp metal edge of your EX20S electric unicycle, giving you a more comfortable option to lift or carry the EUC. The centre hole is to allow fitting without interfering with the screw that comes down…
I designed this easy-to-print front fender as a way to increase the waterproofing on my EX20S. The mounting holes line up with those used for the rear fender bracket to the EUC frame, so simply remove the rear fender by removing the two…
Tested with 10mm steel ball bearings (~4g each, 20-pack from Amazon). The printed bar weighs approximately 11g in PLA. With the original pocket position (~87mm from pivot), the counterweight overpowers the 5-ball side and the bar won't…
This is a stand for the Sony Walkman WM-EX20 so that it can stand upright. Example printed in PETG with 20% infill and no supports.
This is base part of ball clock project. The base is big part, that barely fits my Ender 3v2 printer build plate. It tends to warp (when printing at the edges of build plate), I cannot add skirt nor brim and with 0.6mm nozzle and 0.24 the…
