Liczymy pasujące modele…
I haven't done much printing, but I found that neither of my printers care for having the timing belt system going. They were both printing like crap, so for an acid test I took this off both any they started printing great again. So at…
This is a filament runout sensor mount for the Sovol SV06 based on the F688ZZ bearing I had lying around. This one fits on top of the z screws of the SV06 but I have been told inserting one there is a bad practice. The sensor attaches to…
Hello, this is a small upgrade that the z-axis is holding in the z-axis guide without Wobbling. its easy to print and you can you how good your printer is calibrated :-D make it first over the Bearing and than in the z-axis guide its…
My CR10 is a bit modified and the Z steppers have been pushed away a bit from the normal position. This guide allows a wider range of distances but also covers the stock location. Use the bearing (F688ZZ Flanged) and screws (countersunk…
Another spool holder for Creality printers - this one is made to fit two F688zz bearings. Assemble using M8 bolt (50mm long at the very least) and a self-locking nut. My print settings: Printer: Creality K1 Material: PETG/ABS/ASA…
Since I don't use the filament spool holder, the 1mm mount was a little weak. So I remixed it to 2mm, everything else is the same.
