Liczymy pasujące modele…
Print sideways as shown for tensile strength. Add a 30mm M3 bolt and a square (hex works) nut. Some support needed between the holes but not much for easy removal.
Bouton de remplacement pour SodaStream modèle Fizzi. J'ai également réduit le jeu de fonctionnement et fait en sorte que ça libère le gaz un peu plus tôt lors de l'appui, aligné un peu plus le ressors pour le fonctionnement. J'ai imprimé…
Button Replacement for Sodastream Fizzi - remixed from great work by eboy23 STEP provided for easy editing. Print Settings: Printed on MK4 with 0.2mm STRUCTURAL Profile. I upped infill to 25%, and set to 3 perimeters. I printed at 45…
Button Replacement for Sodastream Fizzi - remixed from great work by eboy23 STEP provided for easy editing. Print Settings: Printed on MK4 with 0.2mm STRUCTURAL Profile. I upped infill to 25%, and set to 3 perimeters. I printed at 45…
The SodaStream Fizzi model has a habit of dribbling water after you remove the bottle. A little water doesn't hurt the unit itself, but it runs onto whatever table or shelf it sits on, leaving spots and possibly damaging the surface over…
I switched from sodastream CO2 canisters to a 5lb tank. The instructions for the hose kit recommended drilling a hole in the back cover of the Sodastream. I created this base with a notch for the CO2 hose. The model was printed in PLA…
I quickly whipped up this base for a soda stream fizzi model. The goal was to have an extension on the bottom that allowed a C02 hose to connect to a larger tank. I could have just left the back off or drilled a hole in it, but what is…
