Liczymy pasujące modele…
Summary I bought the Odroid HC4 to use as an offsite backup target for my server. I couldn't really trust the toaster-like case, however, so I decided to model a new case for it. Hardware and assembly You'll need: the original screws. 1…
Time Capsule alike sized case for harkenel's odroid-hc4 board and two 2,5'' ssd/hdd disks supports only 2,5'' Disks (up to 20+/-5 mm height - like 4 or 5 TB models) everything, except hdd_holders, can be printed without supports Update…
ODROID HC4 NAS CASE Updates: Added 2.5" HDD support. Added 120mm fan version. About This Design If you're looking for an alternative case for your Odroid HC4 that fits 3.5" HDDs and 2.5" HDDs , you've come to the right place. Many of the…
Hardkernel's Odroid HC4 is a great SBC for a home NAS, but the toaster case didn't fit my needs as I don't intend in using 3.5" drives. So I designed a minimal case that allows for two hot-swap 2.5" up-to-15mm height HDDs. Parts needed 2…
This is a 12mm (1/2") guard for the Remington HC4250 that is much shorter than the stock guard, allowing you to trim moustaches and beards easily. This needs quite a few supports. Check out Tinkercad for the object for modifications…
Original model by orubap - https://www.thingiverse.com/thing:2547915 This remix adds dual Skadis pegs to the back of the 4 shelved Remington Quickcut Stand.
I uploaded 2 versions: old (with foot) and new version. The old version needed 4 feets because the Odroid card was too low. Please use the new version that correct this issue. Here below the BOM that I used to make it. You'll need: Odroid…
You can turn a regular through hole crystal in HC49 package into a SMD variant using this isolation pad.
The main feature of the Odroid HC4 is its ability to connect two HDDs, so it makes for a nice NAS solution, but it can also serve as a decent media center device or even combine the two roles. I recently upgraded the NAS side of my setup,…
