12 modeli
This harddrive holder for the compact case Inter-Tech IM-1 / Sama IM01 has four 3.5" HDD drive slots and is modular (you could print just the lower two first). The individual drive holders are screwed together by a couple M3 screws. It is…
Broke the SFX PSU Bracket that came with the case so I made this one, looks much better anyways. Leaves just enough room for a 25mm thick fan on top.
!!! New version is available https://www.printables.com/cs/model/756752-krux-naos-sama-im01-reworked-v2 !!! This is version is archived only and there will be no more updates. V2 is now active !!! New panels and fan brackets with better…
I made this simple handle to carry my SAMA IM01. It utilizes the back 80mm fan mount UPDATE 10/8/2024: After many month of lugging my PC to and fro, the handle still held up very good . Ultimately , I went with 40mm M5 screw with 2 thick…
This is a tower cooler spacer I designed for my Sama IM01 using a DeepCool AK400 Cooler. It bridges the gap between the rear cooler fan(25mm Thick) and the rear of the case to bring fresh air directly from the rear into the heatsink.…
This is a mount to put an 8BitDo Ultimate C or any other XBox like controller onto the front of the SAMA IM01. It works by sliding onto the sheet metal of the front panel (~2.5mm).
I printed these in PLA, make sure the front one isn't over the exhaust at the top. I made the bottom hooks pretty wide to accommodate leaving the included folio cover on the back, feel free to make it a little tighter if you want. Highly…
Compatible With Dimension One Neck Flex Jet Pillow Carrier Rail, 2 Needed. DIM01510-607G
Hi there, We purchased a mobile for our baby and found there was no way to effectively mount it on the bassinet. So I took it upon myself to design a new mount for the bassinet. It works brilliantly and is easy to install. The pole 3mf…
This is a clip to extend the side panel of SAMA IM01 by 6mm It was designed to avoid interference with the side panel when trying to install Deep Cool AK400 Digital in this PC case. Please remove the original and replace it. I think it…
This is a tablet / portable monitor holder for the Sama Im01. It screws (3x M3 screws) into the hole spacing of the steel cover. My tablet (MiPad 6) has a magnetic back, so it stays nice and secure. However, if you intend to use it with…
This is a mount to put an 8BitDo Ultimate C or any other XBox like controller onto the front of the SAMA IM01. It works by sliding onto the sheet metal of the front panel (~2.5mm).
