16 modeli
Replacement compound gear for an Intek TQ81Bc paper shredder 7T Straight Press = 30-deg module = 1.61 36T helical, 15-degree Press = 20-deg module = 0.82 FreeCAD file included When printing, you could slice the bottom of the model at…
Print flat with 100% infill. The lower the layer width the better.
These are models of the bearing blocks used in a Schwintek inverted slide system. It is very hard to buy these and they are expensive when you can find them. I was able to find a set on ebay from a scrapyard in order to fix my trailer.…
-simple ceiling bracket for projector Byintek K20 (smart version) but it is same like basic version Print instructions -30% infill -4x M4x20 hex screw
Raijintek Fan 120mm Abdeckung Für die 120er Lüfter abdeckung schönes schlichtes Design
the support was made for the heatsink in question, mounted on a Tesla M40 nvidia, before with the 120mm fans it went to a maximum of 45/50 ° with this support for smaller fans, it went to 40/42 ° maximum, P.S. I used the noctua 92mm slim…
the support was made for the heatsink in question, mounted on a Tesla M40 nvidia, before with the 120mm fans it went to a maximum of 45/50 ° with this support for smaller fans, it went to 40/42 ° maximum, P.S. I used the noctua 92mm slim…
Bonjour créateur, Je vous présente ce modèle que j’ai dessiné, Les instructions d’assemblage sont disponibles en téléchargement Pour l’impression, je fournis un fichier 3mf, sinon un gros remplissage n’est pas nécessaire et il n’y a pas…
Für das gehäuse vom raijintek Raijintek Coeus Evo Front Deckplate
Material: TPU (BFlex) Supports: No
its a cover for the holes over the screen (look at the picture)
I wasn't happy with how restrictive the stock top cover was so I created this. Cover is friction fit so don't be concerned if both don't just fall right in. Put the ends in first then push the centers in. SIDE NOTE (The USB-C is missing…
Display Holder for WINTEK WD-C2704M-1HNN Category: 3D Printer Parts
I have had a hard time keeping my older Briggs Intek engine air filter to seal properly. I designed and printed a new filter holder that can be secured tightly with 2 springs and a bolt to tightened down on the critical seal going into…
Foldable wall mount designed specifically for the Byintek projector (dimensions: 22 cm width, 15 cm height, 20 cm depth). Printed in PETG using a 0.4mm nozzle . Requires supports on certain parts (I used organic/tree supports). Assembly…
Bonjour créateur, Je vous présente ce modèle que j’ai dessiné, Les instructions d’assemblage sont disponibles en téléchargement Pour l’impression, je fournis un fichier 3mf, sinon un gros remplissage n’est pas nécessaire et il n’y a pas…
