Liczymy pasujące modele…
This thing holds a Magswitch MagJig 95 so it can easily be mounted to something else. For my use I mounted two of them to a piece of plywood to make a drill press fence. It could also be used for other jigs on a table saw, router table,…
It's circular so I don't have to worry about orientation. The inside tolerances are pretty tight so there isn't much play.
Remixed from @exnerd's design to fit the smaller Magswitch MagJig 95s. I printed in PETG at 0.3mm layer height with 15% infill, no brim or supports. I gave the MagJig 95 hole and slot an additional 0.2mm tolerance on each side, for a good…
Heyho I have constructed a system around the MagJig95 switching magnet (Foto below). Here is derived from it a base optimized for the handle. This allows you to lift/hold lighter magnetic parts without getting dirty or not being able to…
Featherboard for holding material against a bandsaw fence, e.g. for resawing tall stock. Secures to table using two MagSwitch MagJig magnetic clamps. Additional materials: 1x 2x6" piece of 1/4" thick flexible material (ex. Speedball Lino…
Table saw featherboard for MagSwitch MagJig. Additional materials: 1x MagSwitch MagJig
This base holds 2 Magswitch 150 clamps, and is designed to attach to the Magswitch universal track, which can act as a fence, hold clamps, hold-downs, featherboards, etc. The mounting hardware in the photo is included with the universal…
This is a fixture I threw together for attaching a misting/cooling system to my belt grinder with a Magswitch 8110004 Magjig 95 switchable magnet. It could easily be adapted to other things.
Your MagJig 95 will embed in this puck. There are six perimeter holes threaded for 1/4-20 into which you can insert a cap screw or bolt to whatever depth you need for your hold down application. I printed this in PETG with 50% infill and…
Printed in PLA on Bambu X1C, has a pretty tight friction fit on the Magjig 150's. You may need to scale a bit depending on your filament and shrink rate.
