8 modeli
The original clips to hold the filter closed broke, so I designed a 3d printable replacement. It's a pretty tight fit, you may have to upscale it in the slicer a couple percent if it's too tight for you. It has a notch so it clips in…
This is a wall mount bracket for the Maytronics Dolphin Nautilus CC Plus Robotic Pool Vacuum Cleaner. This bracket should work on a wide verity of Maytronics products because most of them use the same power supply. Use some super glue to…
Replacement for a broken guide wheel. Maytronics is shipping me a new guide wheel but that could be a few weeks before it arrives so I printed this and I am back up and running. I printed in PETG and it's been in the pool for over a week…
This is the replacement clip that goes under each side cover and hold them to cover the filters
This is a replacement Cork (Item #9982275 by Dolphin Cleaners) for a Maytronics Dolphin Nautilus CC Plus. I printed in PLA with a .4mm nozzle, .2mm layer height, and 75% infill. There isn't much force exerted on the part and it has held…
Maytronics assumes the bearing is going to stay in the right position because of the plastic housing. In general, they are right. But if you disassemble it to replace any part, just may find that during reassembling, the bearing wants to…
Printed with PETG. It does not require any support
Having a pool in the northern Midwest of the U.S., spring opening usually requires removal of leaves and other large debris from the pool. Typical pool cleaner filters are way too fine to effectively remove them. These filters let you…
