Liczymy pasujące modele…
Cable Gland to my electrical distributor to protect my emergency power line cable.
Wydruk około 0,94 €–1,15 € nettoWstępna wycena dla PETGMateriał u źródła: PET
its a prop for mm2 cosplays or for display or just for your average Roblox fan (it is recommended to print with , and it is a really sharp object so be carful when removing supports or when being held.)
A mm2 knife for display or usage as a prop, this model is not sharp but still be carful as i t has a few sharp edges but very little. It is recommended to print with supports to ensure it prints properly and has a 3d look to it.
150mm2 magnetic screw tray. Upgraded my original design to hold larger screws, etc. created to assist in appliance/computer repairs. Use 10mm X 2mm round magnets and glue plugs in after. Can find on eBay, exactly as these below;…
Ever wanted to have your own Murder Mystery 2 candy? Well, here it is!
I designed this so my RMM2050 wouldn't be so “tippy” when I set it down on my desk or other level, stationary surface. It has a single hole in the bottom so you can fasten the holder to your surface if desired. Otherwise I recommend…
Prints upright with no supports. The MM1000 or MM2025 Motorola MoCA bridge fits inside with ports facing down. It's not a super-tight fit, but the weight of the coax and ethernet cords keep the unit in the mount securely.
Měrky k určení průřezu pevného jádra vodiče. Na jedné měrce jsou vždy kombinované dva různé průřezy. Lze navléknout na běžný kroužek na klíče. Průřez se určuje nasazením drážky měrky na odizolovaný vodič. Pro vodiče: 1,5mm2 2,5mm2 4mm2…
UMM2028 system is just a name to group compatible models. Uses 20 mm horizontal x 28 mm vertical hole spacing. Needs longer than stock screws for mounting to top of stock console. Needs M3 melt inserts for mounting the additional mounts.
Clamp for organizing your electrical wiring, designed for 2.5mm2, outer diameter 3.25mm (1/8"). Category: DIY
Plate for dual power switch to switch on printer and laser(for safety) it can be mounted in a 20x20 aluminium profile
We upgraded our printer at work to an MMU2, which came with a set of five spool holders and rollers. However, I modded the MMU2 with a pass-through adapter to allow for easier swapping between our various filaments. By redesigning MTB3R…
1:1 scale LPCAMM2 DRAM module. Modelled after a Samsung 32GB module. Safe for protogen consumption. Can be used as a prop if you scale it up. Will print best with a 0.2mm nozzle if you're printing 100% scale, but you can provably get away…
to attach cables need 6 small screws, to attach holder use small M3 screw and nut I printed it from ABS
Laser unit Mount to be attached in Mendelmax 2 printer
the latest version to the reinforced slingshot family
Uses 20 mm horizontal x 28 mm vertical hole spacing.
Upravené víčko KOPOS V 68_HA s prostupem pro vyvedení kabelu 3x1mm2.
A direct replacement door release push button designed for the Toshiba ER-SS20 series microwave oven. The original plastic retainers and actuation pins on these units frequently snap under repeated pressure. This reinforced 3D printable…
Recently made a mess pouring coffee grounds into the filter basket, got really annoyed and made this to funnel the grounds in properly. Printed in PETG, PLA should work fine. However make sure your filter basket isn't piping hot, as it…
