Liczymy pasujące modele…
Made as a replacement for MOZ7's GPSmount, if you have a GPS M10Q model, 25x25 mm mount. There is a slit for strapping it down with a ziptie for extra security. Made using fusion 360. Printed on Creality CR6-SE. Not really suitable for…
Bumper for Geprc MOZ7 frame. Two versions Just bumper Bumper with dual ELRS antenna mount Insert antenna into bumper can be little tricky because entry space is only 0.5mm. I used Happymodel ELRS antenna. For example antenna from…
I made this remix to be able to install the BetaFPV 2G4 T-Antennas to the front of the GEPRC MOZ7 O3 frame. The base is now a little thicker and there two holes for M2 screws with recessed heads (M2x10). This way you install the antenna…
The camera is held on by the bottom screw that goes through the bracket. A "plug" is created instead of the second screw For print use TPU UPDATE 2.11. 2025 - add adjustable insert
GEPRC MOZ7 V2 GPS Mount This model is designed to accommodate a smaller GPS unit than the original mount was intended for. Weight is reduced by more than half. Compatibility Flywoo GOKU GM10 PRO V3 BZGNSS BZ-251 Others with same…
Bumper for Geprc MOZ7 frame with horizontal ELRS antenna mount I recommend printing upside down. Print from TPU
I needed a way/place to mount the Vi-Fly Finder 2 to my GepRC Moz7 frame. I recreated the front antenna mount that slides/snaps onto the carbon fiber frame peg thing and it still will house the antenna, but also has a box to put the…
TRUE diversity antena ELRS 2.4 GHz mount for FPV drone GEPRC MOZ7 v1 located bellow main camera. Orientation is exactly 90° as recommended for TRUE Diversity technology give you the best coverage of the signal even in the blind spots…
For print use TPU
Antenna mount designed to attach the Radiomaster Boxer antenna to the front of the GEPRC MOZ7 V2. While the antenna is originally intended for use with RC transmitters, in this setup it is repurposed to handle radio control, telemetry,…
I needed a quick, temporary solution to mount four SMA antennas on the MOZ7, so I designed this to also allow an SMA antenna to be installed at the front. Hardware: 4x M3x5 screws 1x SMA pigtail Support my work: All of my models are…
To keep the antenna from vibrating, I also secured it with a zip tie. Print from TPU
Print in TPU, standard settings
The MIPI cable supplied with the Edge T3 is too short to fit the T3 Air unit as intended in the Geprc Moz7 v2 frame. This small bracket is my solution to solve the issue by mounting the VTX further forward. Run the MIPI cable under the FC…
It's just a reupload, so I earn nothing from this. I'm just helping you guys out because I have the Moz7 myself. Print Settings: Filament: PETG - I used PETG for the quality, but you can use something else too. Infill: 60-70% Supports:…
