P
PrintablesMst3ch
NIGHTHAWK MR60/MS60 WALL MOUNT
Flat on the bottom, no support needed
- Pobrania
- 176
- Polubienia
- 17
- Ocena
- 5
Wyniki wyszukiwania: mr60
Liczymy pasujące modele…
P
PrintablesMatěj Zapletal
Wall mount for TP link Archer MR600
Wall mount for TP link Archer MR600 ASA 0,2
- Pobrania
- 141
- Polubienia
- 5
- Ocena
- 0
P
PrintablesSeeed Studio
3D Print Enclosure for XIAO 60GHz mmWave Sensors MR60FDA2 and MR60BHA2
The MR60FDA2 and MR60BHA2 Sensor leverage 60GHz mmWave technology and offer reliable human presence & fall detection, and human presence, breathing and heartbeat detection respectively. Featuring light level sensing, an RGB LED for…
- Pobrania
- 103
- Polubienia
- 13
- Ocena
- 0
P
PrintablesMrFox
MR60-M Stecker Gehäuse
Als Datei ist das Gehäuse und eine TPU Klappe dabei um denn stecker dicht zu machen, kann nach bedarf hoch unter runter sklaliert werden. Benötigt werden zwei M4 Schrauben. Der stecker selbst wird einfach von hinten ins Gehäuse…
- Pobrania
- 52
- Polubienia
- 2
- Ocena
- 0
P
PrintablesBen Goldberg
Amass MR60 panel mount
panel mount connector for the amass mr60 3-pin connector. uses m3 screws, max panel width 4mm? I designed this for sheet metal.
- Pobrania
- 40
- Polubienia
- 2
- Ocena
- 0
P
PrintablesJonathanC
MR60 Male and Female Connector Covers
Covers for MR60 connectors. After soldering cables smear 5 minute epoxy onto the soldered joins and the end of the connector. pull cable back and click connector into place. once dry, fill with regular epoxy. The tpu ring provides a seal.…
- Pobrania
- 38
- Polubienia
- 1
- Ocena
- 0
P
Printableskroyster
Foil Drive v2 Cable MR60 Plug Cover
Cover your FD cable plug when disassembled from your Foil Drive system to keep dust, sand, etc. out. Snaps snugly into place. I recommend PETG. A stiff 95A TPU might also work. I think PLA would be too brittle. See my other related parts…
- Pobrania
- 19
- Polubienia
- 3
- Ocena
- 0
P
Printablesrichv
FoilDrive MR60 Unit connector
Print in petg-cf or ASA, for motors with attached wires like the flipsky 6384, feed the wires through the 3 holes on top, then solder the MR60 connector, push the MR60 connector into the housing until it rests against the backstop lip.…
- Pobrania
- 17
- Polubienia
- 2
- Ocena
- 0