Liczymy pasujące modele…
This is yet another Samsung door mullion repair piece. There are a couple designs out there, and this is my attempt. This is the flipper that closes the center door flap on several Samsung refrigerators. It fits quite well, I've installed…
If you have a Samsung refrigerator with a French door, you know there's a little mullion flap between the two sides of the door that slides into place when the door closes to insulate the gap. You may have also at some point accidentally…
Originally modeled in Tinkercad as a replacement for a lost hinge courtesy of my kids…. Printed in PLA, general, defaults are ok, supports recommended for pin. This should slide onto the hook built into the door, however, in my case,…
Needed to mount a full size HID RP40 to an aluminum storefront door frame. Should work with most other full size prox card readers or many other devices that intended to mount to a single-gang electrical j-box and are 120mm x 80mm or…
The small top hinge tab on the Samsung refrigerator mullion flap (the flipper that seals between the two French doors) often breaks over time, leaving the flap loose or unable to open and close properly. This 3D-printed replacement piece…
A family member asked me to design these for the windows of a 1980s home in the US. The original, clear plastic clips were breaking and they needed more than a dozen, so I set about designing these. The clips hold in the bars (plastic or…
I had a job that needed to cover the existing holes in the metal door frame from a HID mullion mount card reader. Card readers on the inside of the building were removed. Customers answer was blue painters tape. I couldn’t leave it like…
The small top hinge tab on the Samsung refrigerator mullion flap (the flipper that seals between the two French doors) often breaks over time, leaving the flap loose or unable to open and close properly. This 3D-printed replacement piece…
Just an enhanced version of the mullion lip, director, end cap thing on Samsung French door fridges.
GE refrigerator door flipper seal track (called striker top mullion) approximated and taller. The left door flipper was jumping out of the track on my new refrigerator and I am trying to print a temporary fix that has a taller track until…
Print with PLA or PETG and infill density at 100%
This is a remix that uses no supports and no glue or screws (so far). That way, if it breaks, much easier replacement (45 minute print) I used Shapr3D to make a cover piece (PLA) to cover the gap made by the broken flapper (image…
