Liczymy pasujące modele…
This is Ikea Navlinge desktop lamp holder holder for IKEA Skadis pegboard. This item is inspired by IKEA SKADIS Collection by CSD Salzburg, it uses the same hook system. Check out the collection of other IKEA Skadis holders I made .
A custom mount to install an IKEA Navlinge light on the edge of the IKEA Hemnes bed / couch
The light fall of his support, i make "Bague de verrouillage" for stop it with screw M6 and a square nuts M6. I follow the switch on the floor, i make “Calle intérupteur latéral” with “Platine Calle intérupteur latéral”. If you need…
Made this lamp cover to reduce the amount of light for changing the baby at night. There are two version, one 2mm thicker at the cover than the other.
An easy way to keep your desk clean, placing your headset on the Ikea Navlinge Led Lamp. The second file is an adaptor to place my phone (see photo)
Custom mount to put an IKEA Navlinge lamp on your bed's headboard. You need to destroy the original clip to free the cable. Then you can assemble my mount. The two "holding" parts are screwed to the main part with M2 screws and inserts.
A flower shaped lampshade for the IKEA Navlinge clamp lamp. A couple of notes on this one: It's a very tight fit (by design) I actually had to warm it up with a bit with a hairdryer to get it to fit, but it went on ok without breaking. I…
The light fall of his support, i make "Bague de verrouillage" for stop it with screw M6 and a square nuts M6. I follow the switch on the floor, i make “Calle intérupteur latéral” with “Platine Calle intérupteur latéral”. If you need…
UPDATE : The previously uploaded model did not have a recess for the cap -- I have uploaded a new version 1-1 with it
Printed sideways with custom tree supports for upper peg
A flower shaped lampshade for the IKEA Navlinge clamp lamp. A couple of notes on this one: It's a very tight fit (by design) I actually had to warm it up with a bit with a hairdryer to get it to fit, but it went on ok without breaking. I…
This is a remix of the Ikea NÄVLINGE mount for 3030 B-Type aluminum profile by Michl to attach the light directly onto the wall. It uses a single screw, which works well (I put screw into a stud, so made it tight to the wall). Now I have…
Printed with 20% infill. 3 Perimeters - .6 Nozzle - 3mm Layer Height Size of Nut insert has been reduced since photo was taken to support a 7mm M4 Nut.
This is a replacement bracket for an Ikea Navlinge lamp with clamp. The original bracket was a bit wobbly so I designed this one to securely fit the lamp on a bedside drawer unit. Required Parts Rubber insert from the ikea navlinge holder…
This model is aimed to replace the broken spring clip for the IKEA Navlinge table lamp that tends to break when attached to a thick table deck for a while. Minimal deck thickness: 15 mm. Maximum deck thickness: 50 mm. Disassembly The…
Updated previous version since only having one screw allows light to turn as you try to move the head of the light.
