IKEA Navlinge Mount Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This model is aimed to replace the broken spring clip for the IKEA Navlinge table lamp that tends to break when attached to a thick table deck for a while.
Minimal deck thickness: 15 mm.
Maximum deck thickness: 50 mm.
Disassembly
The original mount clip could be simply unscrewed without any issues. Then, wires could be simply unsoldered after removing the heat-shrink isolation to completely remove the broken clip.
Print Settings
The table below contains the print settings used to build the model.
| Property | Value |
|---|---|
| Filament | PETG, ABS |
| Infill | 20% |
| Walls | 5 |
| Top/bottom layers | 5 |
| Layer | 0.2 |
Please note: As the thread is designed without a tolerance gap, it's advisable to adjust the X-Y hole compensation in the slicer when printing the nut (a 0.2 setting should suffice for PETG).
Extra BOM
- Screw M3x30 SHCS - 4
- Screw M3x16 SHCS - 4
- Screw M3x10 BHCS - 1
- Shim M3 - 1
- Nuts M3 - 4