Liczymy pasujące modele…
A starter for the urgent desires. So, com board is ready and was done with M3 heat inserts in mind. As there is currently no idea of where it would commonly fit this is not the final solution. I for my part will fit it into a gridfinity…
Wydruk około 1,35 €–1,66 € nettoWstępna wycena dla PETGMateriał u źródła: PET
I made it because I couldn't find any online and I want it for a project. It is based on the information given by the datasheet . I hope you find it useful.
Mount a PB16 Receiver Out to the side of a Meanwell Power Supply. Two version, one using 3mm heatsets, or self threading using a #6 machine screw. Requires additional nylon spaces as well.
This is a mounting bracket for the FPP PB16 Controller ( https://github.com/computergeek1507/PB_16 ) for the Harbor Freight $9 ammo box enclosure. You may need to make your own standoffs for your specific power supply. The Standoffs I…
I combined a file for a 30mm clamp onto a top and bottom holder for the talentcell PB120B1 to fit the Shywatcher AZ-GTI tripod legs. It is quick install and quick release for easy movement. Print Settings Printer Brand: Sovol Printer:…
Wanted my own, made my own. This Magnetic Poop bucket uses six 10x2mm magnets and a small duct guide which slides into place. The magnets can press into place and there is no glue required. it also prints clean without any support. The…
Mount for a MicroSD card extender that fits into the modem slot of PowerBook 1X0 (tested in a 180)
https://www.bricklink.com/v2/catalog/catalogitem.page?P=60581pb126 Hang on the wall with this stud: https://www.printables.com/model/1189084-lego-stud-for-hanging-2x2-tile-artwork
a stand I designed for Black & Decker HPB12 battery
These are fixes for the plastic parts that hold the handle. It is compatible with the Frigidaire Gallery series model FMT148GPB1, I'm not sure about any other. I've also included a larger bottom part (our microwave door's whole corner was…
A battery holder for the RavPower RP-PB13 battery pack that attaches to the leg of an EQ5 tripod. I designed an appropriate holder (in OnShape) for the size of the RavPower RP-PB13 pack and mashed it onto a z-axis scaled up version of the…
More info: https://www.bricklink.com/v2/catalog/catalogitem.page?P=3068pb1112#T=C&C=1 Hang on the wall with this stud: https://www.printables.com/model/1189084-lego-stud-for-hanging-2x2-tile-artwork
FPP PB16 mounts for the CG1500. Print 2 and use #6 1/2" and #6 3/4" sheet metal screws. Use the 3/4" screws for the top holes and screw through the Controller and mount, into the case standoffs. Use 1/2" screws for all the other holes.…
