Liczymy pasujące modele…
A simple mounting bracket that clamps onto the ScanGauge II with a 10 degree angle (this can be modified in the attached .f3d file) to better angle the screen towards the driver when mounted on a declined surface on the dash like the…
This mount will work for the ScanGauge II device on 1st Gen Tacomas, and should also work for 3rd Gen 4Runners. It is designed to mirror the mounting slides on the stock ashtray, and clips nicely into place when fully seated. The gaps in…
The following Model is for the ScanGauge II. Common problem for the scangauge design is the barely visible LCD backlit display. This is a printable visor to shield the LCD display from the sun - making it more visible to the driver…
Allows rear plug use. Created raised area to help keep the gauge centered and prevent sliding from side to side. Also added file for one with an opposite 5 degree angle. Needed the angle for mounting on a sloping surface. Thanks to…
Best printed in ASA to reduce movement when hot. Extremely tight fitting, raised bumps that go into original screw indents need to be persuaded when removing case. On this one, replaced glue/double sided tape used to attach metal disc to…
A way for your odb2 ecm cars to see all the data without a tablet or phone needed.
This is a mount I designed for the Scangauge II. It was sized to fit on top of the steering column of a 5th Gen Toyota 4Runner, but it may work with other vehicles. The housing has a slight taper and stops in the rear corners to locate…
For sure fits a 2024 GM Denali 3/4T and should fit other HD GM models of the last few years. Uses the lower fastener for the pull handle. Uses 4mm brass threaded inserts to connect the two parts. The portion with the ball mount needs to…
remix so that both sides are flat for a more low profile look, also to accommodate lifted Landcruiser steering column angle.
Printed in PETG, 40% infil, 6 walls, 5 top and bottom walls. Printed without supports on a Bambu p1s. Printed in orientation as seen in screenshots. Uses 1-4/20 heatserts and a chopped-to-size threaded RAM ball.
Remixed both a phone holder and this scan gauge mount for a 1st gen Nissan Titan
remix so that both sides are flat for a more low profile look, also to accommodate lifted Landcruiser steering column angle.
