Liczymy pasujące modele…
Halterung für Teradek Blot 6 an Blackmagic URSA mini 4.6k Kamera Mounting bracket for Teradek Bolt 6 on Blackmagic URSA Mini 4.6K camera
This is a teradek pairing tool. I reccomend you print the two pieces vertically as to not allow gravity to squish the threads. Once it's off the printer, unbend a metal paperclip, heat it up (a lighter works best) and stick it in the hole…
Stand to hold two Teradek Cube 1xx/2xx devices in a position for easy access during shows/streaming. The stand contains 3 pieces which are assembled with dovetail joints for easy setup and teardown. Print instructions Printed in PETG with…
This print does not work right out of the box. It requires a few additional parts and some post-print work: 1. You will need to drill out the 5 screw holes with a 7/64 bit, and add a 45 degree countersink with a countersink bit in order…
A simple adapter to mount the Bolt 6 Reciever to a VESA compatible monitor. Including anti rotating pins & cutouts to not cover the Fanholes. Needs a single 3/8" Screw. I used one from smallrig, available in their 1713 Screw Kit. If you…
Needed a way to mount our Teradek Bolt 4K 12G-SDI 750 RX to the wall. I'm not sure if other Teradek products use the same bolt pattern. 25% infill 4 walls Rectilinear
I resized the model to work with the Teradek Colr. Also, made cutouts for BNC cable.
on the gear side install a m2.5 brass insert and 4 m2.5x12 or 16 screws to act as guides into the holes on the motor. on the screw side add a m2.5x25mm screw and an m2.5 nut to the inside.
attach with the oem screws. thread the holes on the cage by running a ¼ 20 or 3/8 bolt in and out a bunch of times. Reccomend to print out of petg as pla is pretty week in this regard.
This is a reinforced replacement for the Teradek BondPro USB Pens flat support. It was also optimized so when tightening the strap the USB connector isn't damaged by the USB modem. Print instructions The longer and higher parts that fix…
