Liczymy pasujące modele…
Hello all! I needed to make a cup adapter for my large water bottle for my car (which is a 2018 Honda Pilot). I figure that different cars have different cup holder sizes. I designed this one to be strong and be printed with very little…
Large water bottle holder for clicgear (v3 to 4.5) golf push cart inspired by the v4.5 clicgear water bottle holder. This was designed for a 9cm diameter by 25cm tall water bottle ( YETI 18oz Rambler & Thermoflask ). Printing Tips…
A handle for Takeya/Thermoflask 32oz tumblers that are commonly found at Costco. It helps to put a single layer of gaff/duct/electrical tape on the inside of the ring to help it hold/grip to the tumbler (see photos) . Design may be…
Printed in PLA. You may wish to soften the corners with sandpaper. Design hinges on the metal pin that came with the original.
I take my ThermoFlask bottle to many places, and somewhere along the way I lost the sleeve. Putting the aluminum bottle down on hard surfaces can be a hassle (mostly because I forget the sleeve is not there and it hits the surface hard).…
Description: Replacement handle for ThermoFlask food jar. Designed for a snug and secure fit, it attaches easily and provides a comfortable grip. Durable and heat-resistant when printed with PETG or similar filament, making it ideal for…
This is a couch cup adapter for your 1.2L/40 OZ Thermoflask water bottle. this will fit in couch cup adapter with a depth of 83mm and 71mm diameter (with silicone protective boot)
I created this ThermoFlask 40oz cup holder adapter for my 2017 Kia Sorrento. It fits pretty well but can be a bit snug with the rubber bottom on the bottle. I printed it with ASA at 30% infill which is likely more then needed.
This model is a bottom end cap with center hole for a Thermoflask 40 oz/1.2 L. Model is for supporting for tailstock end during laser engraving. The center support for the center hole could be removed. Clean up the model, and use as a…
Printed with PETG, it was ~ 35 hour print which was quite lengthy in my opinion. I printed at 10% in-fill. Fits 4x standard 40 oz Thermoflasks. Has a mesh like location at the bottom for water to drain out.
Hi - In order to learn to desing in Blender, I made these useful pieces for my ThermoFlask Cup. I already lost the originals some time ago. It works properly, hope useful for you. The gasket I printed in TPU, and cuplide in PLA.
This is an odd creation. My daughter lost her ThermoFlask, we walked around her entire school and never found it. I got the bottle as a 2-pack from Costco, I didn't want her to lose the other one and be forced to buy another two. So I…
