Liczymy pasujące modele…
EN: The Cannondale Topstone Carbon has a cover in front of the bottom bracket for a battery that is usually not needed. I have constructed a cover in which two CO2 cartridges are inserted at the top and at the bottom, i.e. in the frame,…
Two part rear fender mount for Cannondale Topstone Carbon. The upper screw mount should be quite universal for different fenders, while the lower clamping mount is specific to the SKS Velo 42 Urban Fender that I reused from an old bike.…
My derailleur hanger been broken by stupid reason and i thought it's a good opportunity to check is it possible to replace it with printed part. I couldn't find pre-made model, so designed it myself. Don't try do it with PLA or PETG, it…
Toptube storage box for Cannondale Topstone Carbon. It uses the existing bottlecage style mount (M5 Screws 65mm apart) and follows the toptube shape. It has plenty of clearance to the steering tube that could be used to increase storage…
Little cap on my frame was missing, a quick print with TPU made the trick! A hole inside the design will make it (i hope so) easyer to remove if it need to. It is a really tight shape, a bit hard to install. But this time i wont loose it.…
Note: I also had to Dremel the rear fender a little bit to prevent it from interfering with the front derailleur on my 2x GRX.
This is a plastic part of the chain guide assembly for Canondale Topstone gravel bike. For this project, best is to use some durable, carbon reinforced filament. I am using PETG-CF, we will see how long this will last.
I created this part to solve an issue where the rear fender starts to sag over time , putting strain on the integrated rear light cable. In my case, the sagging eventually caused the cable to be pulled out of the rear light . This clip…
EN: The Cannondale Topstone Carbon has a cover in front of the bottom bracket for a battery that is usually not needed. I have constructed a cover in which two CO2 cartridges are inserted at the top and at the bottom, i.e. in the frame,…
