Liczymy pasujące modele…
Because the original rear wheels of Neato and VR100 are very hard they make a big noise on tiled floor crossing the gaps between the tiles. If you print the attached file with white TPE and replace the hard wheels with the new ones, you…
These are models for the two little wheels in front of the Vorwerk 100 vacuum robot (just behind the roller).
The dirtbin by LazyOdin fits perfect in my VR100 robot but looks a bit strange. That's why I added a lid to cover the whole bin bay. Like the source by LazyOdin it also uses the roomba 880/900 dirt bin filter. Edit: After four months of…
Because xecutor was so kind to attach his OpenScad-File of his wheel I was able to modify this wheel (even if I'm not so familiar with OpenScad). It now can be mounted on Vorwerks VR100 in the same direction like the original wheel,…
The stock side brush belt of the VR100 and Neato vacuum cleaner robots tears off after about two years. This part can replace the defective belt. Printed with printable rubber the belt will never rip again. Print Settings Printer Brand:…
I got an used VR100 as spare parts donor that was completely intact apart from a broken display and a the missing green handle that you need to lift the dustbin. So I re-created that little piece to complement the dustbin. Update: added a…
Of course, cats are cute. But two of them with much, much fur killed my vacuum cleaner robot meanwhile three times. There is a constructive issue on the main brush motor. There is a wide gap between the motors case and the output drive…
This is a safety clip for the Somnium VR1 Headset to make sure you can close the lid of the storage box, but without damaging the cables. So you can let your Headset plugged into the PC, while you can store the VR1 headset safe in the box…
Snap lugs in the tray of the dust compartment on a Vorwerk Kobold VR100 vacuum cleaner robot were broken, so it was not possible to use the cleaner anymore, which was otherwise still working fine. There are no official solutions and it's…
A mounting for the Thrust master HOTAS X/4 Etc. Designed for the YAW VR 1 Motion simulator. Intended to bolt to the rim of the YAW vr bolt, holes have yet to be calculated as I'm printing a prototype at the moment. Intent is to double…
