1 / 7
PowerX-Change Power Socket to mount to BOPLA ET-215 case — image 1
1 / 7

PowerX-Change Power Socket to mount to BOPLA ET-215 case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Base for connecting an Einhell (PowerX-Change) Battery to two flat connectors so you can power your own devices.

Rating
0 / 5
Likes
5
Downloads
28
Makes
0
Views
259
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

This socket is meant to be mounted to a BOPLA ET-215 enclosure (size 120 x 80 x 57 mm³) for ~18€. It therefore can utilize two of the original mounting holes of the case. The two others need to be drilled, because the holder had to be made smaller to be able to get the battery off the socket again.

Like this it can power the device you built in the case. I built a DPS5005 in it (a DPS3003 or DPS3005 would have been sufficient).

For printing you will need two supports at the overhang.

Pause the printing, when the four hex-holes are complete to lay nuts in them. Like this you will have metal-threads that will hold perfectly.

The flat connectors are crimped to the cable, a small cable tie is wrapped around it and placed in the recess for strain releaf and then glued in with some hot melt glue. I filled it over the top and cut away the excess with a box cutter. I also cut some slots in a temporarily used piece of wood to hold the crimps while applying the glue.

 

Tags