FNIRSI HS-01 Soldering Iron Case with Electric Screwdriver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of a case in order to include my electric screwdriver with minor tweaks to the design.
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 138
- Makes
- 0
- Views
- 1,311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Just a case to carry my soldering iron, electric screwdriver, some hex bits and some tips for the iron that also works as a stand for the soldering iron.
Anything with the following dimensions will be able to fix in the screwdriver slot:
- Diameter: 16mm
- Length: Below 185mm
The bit holder allows for 16x 4mm hex bits.
It uses 1x608 bearing to hold the soldering iron, 6x M3*28mm screws and 6x M3 nuts.
It was printed with my Anycubic Kobra 2 Neo, at 0.2 layer height, at 40% rectilinear infill in PLA. In case the measurements of the case seem off I suggest going to the original author and downloading the model from there and separating the case, I used my slicer in order to separate it.