Filament drying hood
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament drying hood
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 19
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hey there,
Recently, I had some trouble with wet filament, but I didn't want to buy a dryer as most of my filament doesn't last long enough to get wet :D
However, to dry some of the rolls once in a while, I made a drying hood to dry the filament on the printbed.
I equipped the hood with a slow USB fan, just good enough to move some air. Furthermore, I added a humidity (and temp) sensor.
Every 5010 fan should work, but remember, you don't want to cool down the printbed, so take a slow one. I used this one.
As far as I know, most moisture sensors should work either, but I used this one.
If you need an extra gcode you may take a look at this one i've found at printables.
I designed the hood to fit spools up to 90x210mm
If i have forgotten something, please don't hesitate to ask!
(Please don't look too close on my printed version as I used wet filament :D)
Got support, poop and failed prints? Recycle it!