Saturn 4 Ultra S4U exhaust to vent pipe and pc-fan connectors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Connectors for making a vent system on the cheap for your 75mm Elegoo exhaust port to an 80mm vent pipe and pc fan.
- Rating
- 0 / 5
- Likes
- 53
- Downloads
- 243
- Makes
- 0
- Views
- 2,155
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
These are parts to make a ventilation system, you just need an 80mm pc fan (I use a phone charger to run it), 80mm diameter ventilation pipe and some hex-nuts and bolts for it.
I use it for my elegoo saturn but also for my fdm printing too. Think Mars 5 has the same diameter exhaust too.
Printer lid and printer-out need some supports but its minimal.
Printer-out01 attaches to the printer port, printer-pipe-connector goes in the end of the pipe that attaches to it with a twist to keep in place. I use a zip tie to hold that in the pipe. On the other end of the pipe attach fan01-vent-inout and also secure with a ziptie, screw that into the pc fan (I use 80x80x25mm EF80251S1-A99 12V 2pin SUNON fan) and youre done basically if you dont mind running the fan outside. I you want to be fancy, get another piece of pipe, print another fan01-vent-inout, attach to the other end of fan like in the cover photo and run the pipe outside instead of the unprotected pc-fan.
Fan attachment uses 4mm bolts, the printer-exhaust uses 3mm because thats what the S4U exhaust is threaded in.