1 / 1
Saturn 4 Ultra S4U exhaust to vent pipe and pc-fan connectors — zdjęcie 1

Saturn 4 Ultra S4U exhaust to vent pipe and pc-fan connectors

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connectors for making a vent system on the cheap for your 75mm Elegoo exhaust port to an 80mm vent pipe and pc fan.

Ocena
0 / 5
Polubienia
53
Pobrania
243
Wydruki
0
Wyświetlenia
2155
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

These are parts to make a ventilation system, you just need an 80mm pc fan (I use a phone charger to run it), 80mm diameter ventilation pipe and some hex-nuts and bolts for it.

I use it for my elegoo saturn but also for my fdm printing too. Think Mars 5 has the same diameter exhaust too.

Printer lid and printer-out need some supports but its minimal.

Printer-out01 attaches to the printer port, printer-pipe-connector goes in the end of the pipe that attaches to it with a twist to keep in place. I use a zip tie to hold that in the pipe. On the other end of the pipe attach fan01-vent-inout and also secure with a ziptie, screw that into the pc fan (I use 80x80x25mm EF80251S1-A99 12V 2pin SUNON fan) and youre done basically if you dont mind running the fan outside. I you want to be fancy, get another piece of pipe, print another fan01-vent-inout, attach to the other end of fan like in the cover photo and run the pipe outside instead of the unprotected pc-fan.

Fan attachment uses 4mm bolts, the printer-exhaust uses 3mm because thats what the S4U exhaust is threaded in.

Tagi