1 / 8
Makita 18v Portable Soldering Station — image 1
1 / 8

Makita 18v Portable Soldering Station

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A portable soldering solution using a Quicko T12 powered by a Makita 18v battery.

Rating
0 / 5
Likes
11
Downloads
53
Makes
0
Views
645
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Introduction

The goal is to create a portable soldering solution which can be powered from a Makita 18v battery. 

This design uses a Quicko T12 STC Mini controller which is available for under AU$25 on Aliexpress.

Battery Capacity & Safety Warning

This device does not have any low voltage protection for your battery, so be mindful of run time so as not to damage the battery. My testing showed the device pulls about 2amps when heating on 18v.

There is also no fuse, so any wiring issues or other faults could start a fire/damage the battery.

Required hardware:

Printing Notes

  • I printed all components in PETG so it would be more heat tolerant as I expect to use this in outdoor environments.
  • If you make the optional box, the lid, latches, base and insert are all printed as seperate components. The insert fits into the notches built into the sides of the box.

Assembly

General

Front Panel Assembly

The front panel uses a split ring to secure the aviation connector in place while still allowing disassembly if required in the future. 

Before soldering the aviation connector to the PCB, pass the connector through the front panel, from back to front until the frontmost collar on the connector is clear of the front panel.

Place the split washer halves in the front panel recess such that the frontmost part of the washer sits under the collar on the aviation connector. Once the complete split ring is in place, secure the connector using it's own washer and nut against the rear of the panel (see photos).

Once you have the connector located in the panel, place the panel over the rotary encoder shaft and align the aviation connector studs with the holes in the PCB, then solder the connector in.

If you need to take it apart, loosen the nut on the aviation connector, remove the nut on the rotary encoder, then push the panel back towards the PCB so that the split ring halves can be pulled out.