1 / 6
Webcam cable guide for Artillery SideWinder X2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Webcam cable guide for Artillery SideWinder X2
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 153
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I attached my webcam on top of my printer (see my webcam mount for Artillery SideWinder X2 design).
Thus I had its cable hanging and putting at risk my prints.
So I design those two little guides to make sure that the webcam cable stays out of the Z-axis and the printing bed.
BOM
Top mount:
- M5 washers x4
- M5 12mm x2
Z-axis mount:
- M3 T-Slot nut x1
- M3 8mm screw x1
Mouting instruction
Z-axis mount:
- Simply screw the guide with the T-Slot nut
Top mount:
- Unscrew the two M5 screws
- Put washers in the plastic support holes. Two per hole (where the screw heads was laying).
- Screw the guide with the replacement screws (M5 12mm)