Filament holder/stand with a printed roller and 1/2" PVC pipe frame
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple but very effective filament holder/stand with a printed roller for smooth filament unspooling.
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 78
- Makes
- 2
- Views
- 726
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a pretty simple, but really good filament holder / filament stand for your 3d printer of choice!
I made this stand so I can easily swap filament on my Bambu Lab P1P while its inside an exhaust vented enclosure to deal with print fumes. I swapped out the PTFE tube to be longer, and just stick straight up from the printer, out of the enclosure. Then I run the filament from this spool holder into the PTFE tube.
Printed components:
- SB-Filament-Holder Roller - This is what the filament spool rides on to spin around.
- SB-Filament-Holder EndCap - This part keeps the Roller from falling off the pipe it rides on. The end cap also has a small wear surface that contacts the Roller, to make sure its always smooth.
I recommend you print both of these parts with ironing enabled, so the ends are super smooth. Less friction.
You can print them with whatever wall and infill you wish (I did them at 15% Gyroid infill, 3 walls).
Other parts needed:
All the pipe used in this build is ½ inch Schedule 40 PVC pipe, which is easily found in pretty much any hardware store in the USA.
- Pipe (½ in PVC pipe)
- 4x - 3" long
- 2x - 5.75" long
- 2x - 8" long
- Fittings (½ in PVC)
- 3x Tee fitting
- 1x 90 degree Elbow fitting
- 9x screws
- (It doesn't matter what size you use really, its just to hold the pipes in place in the fittings. I used some #4 x ½ inch Phillips head screws.)
- Optional: A piece of foam (if you put a piece of foam on either side of the printed roller, it will prevent it from over-rotating when the filament spool is pulled by the printer, which uncoils a lot of extra filament.)
Assembly:


- Take one of the 5.75" pipes and push it into the printed EndCap. Drill a hole through the pipe aligned with the screw holes on the EndCap, using a 3/32" drill bit. Attach the EndCap to the pipe with 2 screws.
- Slide the Roller over the pipe. Make sure it spins freely.
- Press the 90 degree elbow fitting onto the other end of the pipe. Drill a hole through both the elbow fitting and the pipe on one side, and hold them together with 1 screw. This will prevent the pipe from rotating in the fitting.
- Repeat this process according to the example photo for all the Tee fittings and the other pipes. Make sure the legs of the stand are parallel and that the spool holder is level when sitting on a flat surface. The two pipes that make up the feet on the ends of the legs do not need to be screwed in place.