Circle sorter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a round sorting tray i made in onshape. It's perfect for small things in large amounts. To use, just twist the top untill you reach what you are looking for. Then pour some in your hand and from your hand onto the lid. The ledge on the lid keeps anything from getting lost. When you are done, just tilt the sorter to pour everything back into the compartment and twist to close again.
For assembly, only a single 3mm screw is required to screw on the lid.
The ledge can be a little bit tight to press in, but it is important that it is tightly on, so it makes a good seal.
THE MODEL FILES ARE V2 OF THE CIRCLE SORTER. IT FEATURES A LIP ON THE TRAY TO MAKE IT STACKABLE. ALSO THE LEDGE HAS BEEN CHANGED TO BE A BIT EASIER TO INSTALL.
THE PICTURES ARE OF V1 CIRCLE SORTER.
Printing:
Turn the ledge 180 degrees so the pegs point up.
Print tray and lid in original orientation.
NO supports
I recommend printing with only wall lines for the walls on the tray and lid.