Velociraptor Head and Neckerchief Woggle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Multiple design versions are supplied.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 26
- Makes
- 0
- Views
- 311
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Characters & Monsters
- License
- Creative Commons — Attribution — Noncommercial
There are 4 STL versions available. The “Velociraptor_Head” is the original design file. The “Velociraptor_Head_w_Eye” has a cutout for various color replacement eyes. The “Velociraptor_ Head_w_Eye_Flatbottom” has a flat bottom for ease of printing. And, the “Velociraptor_Neckerchief_Slide” has an additional cut-out for a neckerchief woggle. The “Velociraptor_Eye” fits all versions; just print multiple copies on the platter.
Printing
I used a 0.15mm layer height and put about 1mm of plastic on the outside surfaces as a shell for the heads. Since my printer has a 0.5mm nozzle I used 2 vertical shells and 6 horizontal top and bottom layers. The eyes were printed with a 0.25mm layer height. I set a honeycomb fill pattern with a 15% honeycomb fill density. Support is needed for the heads (especially the eye sockets) but not for the eyes.
Assembly
The eyes glue into the head with the flat-spot in. Any acceptable glue may be used to hold them in place.
Since I printed with ABS, I used a couple drops of acetone for a glue the eyes in place since it dissolves ABS.
Finishing
I employed an acetone vapor polish to smooth the surfaces and merge the eyes with the body. The before and after photos illustrate the improvement.