0.2mm FT Panel Clips (for 2020 extrusions)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Toolless way of Securing thin plasic foil/sheets to any enclosure with 2020 extrusions
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 18
- Makes
- 0
- Views
- 535
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Since I was too cheap to get myself actual Panels till now, I wanted to Secure some Plastic Sheets I got laying around, cant test how well it insulates with the mounts as not all of them are printed yet, but the sheet alone was Insulating enough.
Update:
Finally got to printing all of them out and roughly cutting the Plastic to size and I am getting around 20C over the Ambient Temperature with the bed at 100C, I would recommend just taping the edges off though, as its not the best seal as is, espacially if its not cut 100% accuratly.
Printed with 0.2mm layer Height, didn't test any other.