0.2mm FT Panel Clips (for 2020 extrusions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Toolless way of Securing thin plasic foil/sheets to any enclosure with 2020 extrusions
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 530
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Since I was too cheap to get myself actual Panels till now, I wanted to Secure some Plastic Sheets I got laying around, cant test how well it insulates with the mounts as not all of them are printed yet, but the sheet alone was Insulating enough.
Update:
Finally got to printing all of them out and roughly cutting the Plastic to size and I am getting around 20C over the Ambient Temperature with the bed at 100C, I would recommend just taping the edges off though, as its not the best seal as is, espacially if its not cut 100% accuratly.
Printed with 0.2mm layer Height, didn't test any other.