LayersFactory
Report model
1 / 4
Message Torch Bottle Base — image 1
1 / 4

Message Torch Bottle Base

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Source
Printables
Category
Electronics
License
Creative Commons — Attribution — Share Alike
DetailsMakes & commentsRemixesCollectionsRelated

This is a rather specific base for a message torch. It's designed to fit an Ocean Vodka bottle with a Spark Core / Particle Photon beneath. It's a two-piece print and the top should fit snugly into the bottom.

You can find more project information in the original forum thread (note that I am not the original poster--merely a copycat).

Instructions

  1. Print base-bottom.stl and base-top.stl.
  2. Put your favorite microcontroller in base-bottom.stl. There is a side hole for power/USB/whatever (I used a DC barrel connector for power).
  3. Feed necessary power and control wires through the top.
  4. Connect wires to LED strip.
  5. Place base-top.stl into base-bottom.stl, aligning the cutout in the top to match the bottom so the wires will fit through.
  6. Plug in and enjoy!

Category: Electronics

Tags

particleneopixelthingiversephotonparticlephotonmessagetorch