Pressure Advance Tuning Tower with Height Marks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is modified from the pa tuning tower from klipper doc , added a height mark for easier use.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 297
- Makes
- 1
- Views
- 826
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Public Domain
This is modified from the pa tuning tower from klipper doc , added a height mark for easier use.
(https://www.klipper3d.org/Pressure_Advance.html)
How to use:
Prepare for the test by issuing the following G-Code command:
SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500This command makes the nozzle travel slower through corners to emphasize the effects of extruder pressure.
Then for printers with a direct drive extruder run the command:
TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005For long bowden extruders use:
TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.020Inspect the print and then use the height mark on the model to find the height that has the best quality corners. When in doubt, prefer a lower height.