1 / 7
Swedish trekking/camping hatchet (no supports) for Halloween or cosplay — image 1
1 / 7

Swedish trekking/camping hatchet (no supports) for Halloween or cosplay

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Swedish trekking/camping hatchet for Halloween or cosplay 30 cm long, fits all standard size printers, no supports

Rating
0 / 5
Likes
23
Downloads
149
Makes
1
Views
427
Reviews
0

Updated at source:

Model information

Category
Props
License
Creative Commons — Attribution — Noncommercial — Share Alike

Life-sized Swedish trekking/camping hatchet for Halloween.
30 cm long, fits all standard size printers (256x256mm), no supports needed.

Printing instructions.
- If your slicer takes STEP files, choose those. They're the highest resolution. If it doesn't go for 3MF. 
- Doesn't need much infill. 8% Gyroid worked for me, but I wanted it to be very light. 
- Don't use grid on flat prints like this.
- I went with 3 walls.
- No supports
- I printed in PLA Matte with adaptive layer height, but 0.2 should work fine.
- Print one of each handle sides diagonally on your bed and glue them together.
- The axe head slides on easily. A few drops of glue will set it in place.
- My print is a bit rough, I was in a hurry, so too much speed.
- Printing times with mentioned settings was 50 minutes for each handle side and 45 minutes for the head.
- Added the full handle too if you want to print it in one piece. Keep in mind you'd need supports then.
 


 

Tags